From: Delfs <delfs@NOSPAMapple2.com>
Newsgroups: comp.sys.apple2.programmer
Subject: Re: apparent software loop
Date: Wed, 01 Dec 1999 16:07:20 -0600
Organization: University of Nebraska-Lincoln
Lines: 22
Message-ID: <38459C18.2C3D68D2@NOSPAMapple2.com>
References: <823vc2$sia$1@nnrp1.deja.com>
NNTP-Posting-Host: hc-compsupport.unl.edu
Mime-Version: 1.0
Content-Type: text/plain; charset=us-ascii
Content-Transfer-Encoding: 7bit
X-Mailer: Mozilla 4.61 [en] (Win95; I)
X-Accept-Language: en
Path: newsbox.grin.net!telocity-west!TELOCITY!u-2.maxwell.syr.edu!newsfeed.stanford.edu!headwall.stanford.edu!unlnews.unl.edu!not-for-mail
Xref: newsbox.grin.net comp.sys.apple2.programmer:930

Although most Apples can not just stop, you can halt your Laser128 by
pressing Control-Reset-M.  (release Reset, M, then Control)  Then you
should be in the monitor three bytes past the instruction that was
running.  Happy hacking...

WABROWN@MAILCITY.COM wrote:

> is there an easy method to do the equivalent of a trace
> when "brun"ing an assembly program on a laser 128?
> i would like to get the addresses of the code in the
> apparent loop.
>
> when running the code under dos3.3, the "break" key will
> not halt the program into the monitor (this is my first
> program to run under dos3.3).
>
> i do not have the resources to re-assemble the code; i only
> have the binary of this program.
>
> Sent via Deja.com http://www.deja.com/
> Before you buy.